Instructions d’installation de la niche de douche

Déterminez l’emplacement désiré de la niche et faites le tracé du contour extérieur de la bride KERDI-BOARD-SN, en vous assurant que les lignes sont de niveau et bien droites. Pratiquez l’ouverture dans le panneau KERDI-BOARD de sorte que la niche soit supportée des deux côtés par les montants ou d’autres éléments de charpente murale.

Insérez la niche et fixez-la aux montants à l'aide des vis et rondelles fournies ou de vis à bois ou métal appropriées. Positionnez ces ancrages le long des lignes du raccord entre le panneau KERDI-BOARD et la niche. Vissez tous les ancrages en limitant l’espace entre chacun, mesuré au centre, à 12 po. (305 mm).

Connections between the niche and walls are made using the provided pre-cut KERDI-BAND frame, applied with Schluter SET®, ALL-SET®, FAST-SET®, or unmodified thin-set mortar (mixed to a fairly fluid consistency, yet still able to hold a notch).

Apply the thin-set mortar using a 1/4" x 3/16" (6 mm x 5 mm) V-notched trowel or the Schluter®-KERDI-TROWEL, which features a 1/8" x 1/8" (3 mm x 3 mm) square notched design.

Apply the membrane up to the niche opening and embed into the mortar throughout its entire surface to ensure proper adhesion. Remove any air pockets.

Determine the desired location for the shower niche and trace around the outside of the KERDI-BOARD-SN flange, making sure the lines are level and plumb. Cut and remove the wallboard so that the niche is supported on both sides by the studs or other wall framing.

Insert the niche and fasten to the studs with the provided screws or appropriate wood or metal screws only (no washers). Place fasteners approximately 1/4" (6 mm) from the edges of the niche. Fasten all corners and limit fastener spacing to 12" (305 mm) o.c.

Connections between the niche and walls are made using the KERDI membrane, applied with Schluter SET®, ALL-SET®, FAST-SET®, or unmodified thin-set mortar (mixed to a fairly fluid consistency, yet still able to hold a notch). Apply the thin-set mortar using a 1/4" x 3/16" (6 mm x 5 mm) V-notched trowel or the Schluter®-KERDI-TROWEL, which features a 1/8" x 1/8" (3 mm x 3 mm) square notched design. Apply the membrane over the wall and embed into the mortar throughout its entire surface to ensure proper adhesion. Remove any air pockets. Cut the membrane to match the niche opening.